The short version
- The Ability-to-Repay (ATR) rule (Reg Z 1026.43) says a creditor must make a reasonable, good-faith determination, based on verified information, that the borrower can repay the loan. It considers 8 factors.
- A Qualified Mortgage (QM) is a loan that meets extra standards and gets legal protection. QMs can’t have negative amortization, interest-only payments, balloon payments (with limited exceptions), or a term over 30 years.
- QM points and fees are capped at 3% of the loan amount for loans of $137,958 or more (2026). Smaller loans have higher caps. The dollar figures adjust every year.
- General QM uses a price test: for most first-lien loans, the APR must be less than 2.25 percentage points above the average prime offer rate (APOR).
Why the rule exists
Before 2008, many loans were made with little or no proof of income (“no-doc” loans) and payments the borrower could only afford for a short time. Dodd-Frank responded with the ATR requirement, which took effect in January 2014.
What loans are covered
ATR applies to closed-end consumer credit secured by a dwelling (including first and second liens, and loans on second homes).
Not covered:
- Home equity lines of credit (HELOCs)
- Timeshare loans
- Reverse mortgages
- Temporary or bridge loans with a term of 12 months or less (including a construction loan)
- The construction phase (12 months or less) of a construction-to-permanent loan
- Certain loans from housing finance agency programs and designated nonprofit or community lenders
The 8 ATR underwriting factors
A creditor must consider:
- Current or reasonably expected income or assets (other than the home itself)
- Current employment status (if relying on employment income)
- The monthly payment on the loan
- The monthly payment on any simultaneous loan (like a piggyback second mortgage) the creditor knows about
- Monthly mortgage-related obligations (property taxes, insurance, HOA dues, mortgage insurance)
- Current debt obligations, alimony, and child support
- Monthly debt-to-income (DTI) ratio or residual income
- Credit history
Verification
The creditor must verify the information it relies on using reasonably reliable third-party records, such as tax returns, W-2s, pay stubs, bank statements, and credit reports.
How to calculate the payment
For ATR, the creditor must use the greater of the fully indexed rate or any introductory rate, and monthly, fully amortizing, substantially equal payments. (A teaser rate can’t be used to make the loan look affordable.) Special rules apply to balloon, interest-only, and negative amortization loans.
Record retention
Keep evidence of ATR compliance for 3 years after consummation.
Qualified Mortgages (QMs)
A QM is presumed to comply with ATR, which protects the lender from borrower lawsuits. There are several types, but the exam focuses on the General QM.
Features a QM can NOT have
- Negative amortization (the balance grows)
- Interest-only payments
- Balloon payments (except certain small-creditor QMs)
- A loan term longer than 30 years
- Points and fees above the cap (below)
QM points-and-fees caps (2026)
These dollar amounts are adjusted every January for inflation. For loans consummated in 2026:
| Loan amount | Maximum points and fees |
|---|---|
| $137,958 or more | 3% of the total loan amount |
| $82,775 to $137,957 | $4,139 |
| $27,592 to $82,774 | 5% of the total loan amount |
| $17,245 to $27,591 | $1,380 |
| Less than $17,245 | 8% of the total loan amount |
“Points and fees” generally includes origination fees and points, loan originator compensation, and certain fees paid to affiliates. It generally excludes bona fide third-party charges not retained by the creditor or its affiliates and a limited amount of bona fide discount points.
General QM: the price-based test
Since October 1, 2022 (the mandatory compliance date), the General QM uses pricing instead of the old 43% DTI limit. The creditor must still consider and verify income, assets, debts, and DTI or residual income, but there is no specific DTI cap.
The loan’s APR can’t exceed the average prime offer rate (APOR) for a comparable loan (as of the date the rate is set) by these amounts or more (2026 figures, adjusted yearly):
| Loan type and amount (2026) | QM fails if APR exceeds APOR by |
|---|---|
| First lien, $137,958 or more | 2.25 or more percentage points |
| First lien, $82,775 to $137,957 | 3.5 or more percentage points |
| First lien, less than $82,775 | 6.5 or more percentage points |
| First lien on a manufactured home, less than $137,958 | 6.5 or more percentage points |
| Subordinate lien, $82,775 or more | 3.5 or more percentage points |
| Subordinate lien, less than $82,775 | 6.5 or more percentage points |
The APOR is a benchmark rate the CFPB publishes weekly, based on rates offered to low-risk borrowers.
When figuring the APR for an adjustable-rate loan whose rate can change in the first 5 years, the creditor uses the maximum rate that can apply during the first 5 years.
Safe harbor vs. rebuttable presumption
| QM type | Level of protection |
|---|---|
| QM that is not “higher-priced” (first lien APR less than 1.5 points over APOR; subordinate lien less than 3.5) | Safe harbor: conclusively presumed to comply |
| QM that is higher-priced | Rebuttable presumption: borrower can try to prove the lender didn’t reasonably consider their ability to repay |
Other QM types (know the names)
- Small creditor QM: for small lenders that keep loans in portfolio; more flexible underwriting.
- Balloon-payment QM: certain small creditors in rural or underserved areas can make balloon QMs.
- Seasoned QM: a first-lien, fixed-rate loan held in portfolio that performs for 36 months can become a safe-harbor QM.
- Government QMs: FHA, VA, and USDA have their own QM definitions.
Prepayment penalties
A loan subject to ATR can have a prepayment penalty only if it’s a fixed-rate or step-rate QM that is not a higher-priced loan, and state law allows it. Even then:
- Maximum 2% of the prepaid balance in the first 2 years
- Maximum 1% in the third year
- None after 3 years
- The creditor must also offer an alternative loan without a prepayment penalty.
Numbers to memorize
| Item | Number |
|---|---|
| ATR underwriting factors | 8 |
| ATR effective | January 2014 |
| Bridge/temporary loans exempt if term is | 12 months or less |
| QM maximum term | 30 years |
| QM points and fees, loans ≥ $137,958 (2026) | 3% |
| QM points and fees, $82,775–$137,957 (2026) | $4,139 |
| QM points and fees, $27,592–$82,774 (2026) | 5% |
| QM points and fees, $17,245–$27,591 (2026) | $1,380 |
| QM points and fees, below $17,245 (2026) | 8% |
| General QM price limit, first lien ≥ $137,958 (2026) | Less than 2.25 points over APOR |
| Safe harbor if first-lien APR is below | APOR + 1.5 points |
| Safe harbor if subordinate-lien APR is below | APOR + 3.5 points |
| ARM rate used for QM | Max rate in first 5 years |
| Seasoned QM seasoning period | 36 months |
| Prepayment penalty years 1–2 | Max 2% |
| Prepayment penalty year 3 | Max 1% |
| Prepayment penalty after year 3 | Not allowed |
| Keep ATR records | 3 years |
Memory tricks
- ATR’s 8 factors: “I-E-M-S-M-D-D-C” → “Income, Employment, Mortgage payment, Simultaneous loan, Mortgage-related costs, Debts, DTI, Credit history.” Try: “I Eat My Sandwich Mostly During Dinner Calls.”
- QM “No-No-No-No” list: No negam, No interest-only, No balloon, No more than 30 years.
- Prepayment penalties “2-2-1-0”: 2% for 2 years, 1% in year 3, 0 after.
- “3% for big loans”: larger loans get the lowest cap (3%). Smaller loans get more room because fixed costs are a bigger share of a small loan.
Watch out on the exam
- ATR doesn’t ban any loan type. A non-QM loan (like an interest-only loan) is legal if the lender properly determines ATR. It just doesn’t get QM protection.
- The 43% DTI cap was the old General QM rule. The current General QM is price-based. If an answer says “a QM requires DTI of 43% or less,” it’s outdated.
- HELOCs and reverse mortgages are not covered by ATR.
- Use the fully indexed rate (or the intro rate if higher) for the ATR payment, never just the teaser rate.
- QM dollar thresholds change every year. Know the percentages (3%, 5%, 8%) and the structure, and know that the dollar breakpoints are inflation-adjusted.